SCENE 1 · SPECTRUM GALAXY BPM — NO AUDIO MIDI ⏳ — FPS

PULSE

Audio-reactive visuals for your set

Pick an audio source to begin. You can change it anytime.

Route your mixer's booth / record out into an audio interface, choose Line-in, then pick the interface in the panel. Plug in a MIDI controller before opening this page for hardware mapping.

Controls

Scenes key · MIDI note

Pad / key change

Looks ⇧-click save · right-click clear

Auto VJ A on/off · D bar 1 · N next

Autopilot plays the scenes, your saved looks and every slider below, locked to the beat. Grab any slider, knob or the mono toggle and it's yours for 16 beats. Right-click a pad to leave it out of the rotation.

Show O output · B blackout · H clean

Output window: drag it to the projector, click it for fullscreen (that also hides the address bar). Keep this window open — it drives the show. H cycles panel → HUD only → clean screen.

Record V start / stop · ⇧V pause

Include audio (line-in / mic / file)

Records the visuals only — no panel, HUD or cursor.

Audio input

Input gain 0 dB

Tempo & sync

— BPM Sync offset 30 ms

Sensitivity 1.00 Motion speed 1.00 Intensity 1.00 Hue 0°

Post-FX Bloom 0.90 Trails 0.00

Auto exposure (even brightness across scenes)

Allow strobe flashes Auto-react to BPM/energy Beat-locked camera punch Monochrome mode (M) High quality (sharper, anti-aliased)

MIDI mapping

Connect a MIDI controller, then refresh. Default pads shown.

Light up controller pads

Shortcuts

1…0 - =Scenes 1–12 (number row) ⇧ 1…8Recall saved looks 1–8 AAuto VJ on / off DAuto VJ: this beat is bar 1 NNext scene on the next downbeat BBlackout (fade to black / back) OOpen / close the output window HPanel → HUD only → clean screen FFullscreen V / ⇧ VRecord start-stop / pause TTap tempo SStrobe burst GGlitch burst MToggle monochrome RReset BPM ← →Speed −/+ ↑ ↓Intensity +/−